Section Menu

Campus Televideo

 

channels

 (Click Image to Enlarge)
 

How do I program my digital TV to receive all the University channels?

If you have a digital TV not connected to a cable receiver, it is important to auto program your TV to ensure you are viewing all the available analog and digital channels. Exact details on how to auto program or auto tune digital TVs vary from manufacturer to manufacturer and from model to model. These instructions are generalizations that are meant to describe the way most TVs accomplish this feature. For best results, refer to the owner’s manual for the specific TV you are working with. Most TVs will take between 20-45 minutes to complete this function.

Using the TVs remote control, follow these general steps:

   Step 1: Press the “Power” button to turn on the TV

   Step 2: Press the “Menu” Button

   Step 3: Select “Set-Up”

   Step 4: Select “Antenna” then “Cable”

   Step 5: Select “Auto Program/Auto Tune” then “OK”

 

How do I make my analog TV work on the school’s digital cable system?

If you have an older analog television and your school cable system is digital, your television cannot receive the signal without use of a digital-to-analog converter box. You may purchase an NTSC Clear QAM tuner digital-to-analog converter box anywhere that you shop for electronics. These boxes vary in price from $40.00 to $100.00. 

If you need help or consultation on digital-to-analog converter boxes; please contact 425-4000, and a Cable Technician will contact you.

Please Note: QAM tuners are better for out cable system over ATSC tuners.  Be sure to check your TV to verify that it has a QAM tuner as only limited models have a QAM tuner and others do not have them at all. UTC cannot guarantee the accuracy of this information and you should verify the specifications when you make a purchase.

 

If you experience trouble upon reprogramming your TV please contact the help desk at 425-4000 and a technician will be advised to provide support.

 

 

 
 
©